Day 1:

Day 2:

Day 3:

Day 4:

Day 5:


* (10 sets of 10 reps of 60% 1 rep max)

The training program, which I like to use here, is the German Volume Training. GVT is a program that relies’s on stimulating muscle through neurological pathways. I prefer it because it is basic and gets you to failure without the 1-2 hour marathon workout.

The goal of the German Volume Training method is to complete ten sets of ten reps with the same weight for each exercise. You want to begin with a weight you could lift for 20 reps to failure if you had to. For most people, on most exercises, that would represent 60% of their 1RM load. Therefore, if you can bench press 300 lbs. for 1 rep, you would use 180 lbs. for this exercise.

Rest Intervals:

When bodybuilders start with this method, they often question its value for the first several sets because the weight won't feel heavy enough. However, there is minimal rest between sets (about 60 seconds when performed in sequence and 90-120 seconds when performed as a superset), which incurs cumulative fatigue.

(Interestingly enough, you might find you get stronger again during the eighth and ninth sets. This is because of a short-term neural adaptation.) Because of the importance of the rest intervals, you should use a stopwatch to keep the rest intervals constant. This is very important, as it becomes tempting to lengthen the rest time as you fatigue.

Tempo:

For long-range movements such as squats, dips, and chins, use a 4-0-2 tempo; this means you would lower the weight in four seconds and immediately change direction and lift for two seconds. For movements such as curls and triceps extensions, use a 3-0-2 tempo.

*** Supplemental bodyparts can be trained at the end…rear delts, calves etc…3 sets of 12 reps***

Overload Mechanism:

Once you're able to do 10 sets of 10 with constant rest intervals, increase the weight on the bar by 4% to 5%, and repeat the process. Refrain from using forced reps, negatives, or burns. The volume of the work will take care of the hypertrophy. Expect to have some deep muscle soreness without having to resort to set prolongation techniques. In fact, after doing a quad and hams session with this method, it takes the average bodybuilder about five days to stop limping.

Back to the last page

http://www.bodybuilding.com/fun/jeff6.htm